| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Hypertherm Plasma Discuss hypertherm plasma machines here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
06-18-2011, 09:05 AM
| |||
| |||
mr colt in my manual is says that i need a 30 kw engine drive for full arc stretch, using a rotary phase converter is it still 30kw? the manual shows that 480 volt takes 34 amps during arc stretch, so it i take those #s i get 16.32kw. at 208 its 15.6kw. i just need to know if i need to have a rph that is 30 kw to run or if my kw figuring is right and i can size one to that. thanks for your help bakerj99  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| controller power supply 115/230v OK for Australian power? | Momill | Australia, New Zealand Club house | 8 | 07-07-2011 11:06 AM |
| POWER ONE POWER SUPPLY F24 12 A _ F2412A | CNCadmin | EBAY ADS | 0 | 06-13-2011 11:10 AM |
| I think I want to power my mill through a power strip or surge protector, good idea? | slashmaster | Benchtop Machines | 5 | 10-13-2010 09:28 AM |
| Need Help!- Adding an X axis power feed to my smithy 1220XL milling table.Adding an X axis power | matridium | Smithy | 0 | 05-28-2008 10:37 AM |
| More power from switching power supply | R.thayer | General Electronics Discussion | 4 | 03-10-2007 07:03 PM |
| | |
Linear Mode
