Programming Question, Dwelling on Inside Corners - CNCzone.com-The Largest Machinist Community on the net!

01-21-2011, 10:11 AM

nfrees114

Join Date: Jul 2009

Location: USA

Posts: 69

Programming Question, Dwelling on Inside Corners

permalink

Hey Guys- So I have a question when programming a Hypertherm Edge with Pheonix software. Is there a G code or something else that can let the torch dwell on an inside corner for a certain amount of time? I know in milling when you're doing a drill cycle you can dwell to break the chip. I was just wondering if you could do that on the plasma to maybe help make a sharper inside corner? Any info would help.

Thanks!!

-Nate

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Inside Square Corners	Magnum164	Tormach PCNC	10	08-29-2010 10:07 AM
Need Help!- Fadal dwelling	3bmachine	Fadal	9	03-10-2010 05:08 PM
Milling Tight Inside Corners???	Frogblender	BobCad-Cam	11	05-28-2009 07:21 PM
Need Help!- Programming Question	pgf545	HURCO	15	03-16-2009 03:10 PM
Programming question	AMCjeepCJ	Milltronics	6	01-10-2006 09:58 AM

All times are GMT -5. The time now is 03:54 AM.