Hypertherm PMX30 - CNCzone.com-The Largest Machinist Community on the net!

cruzin · #1 09-07-2010, 09:43 AM

Hello, new to the forum, I would like to have a cnc plasma cutter someday. I have a hypertherm PMX30 to use. Is it possible to use it for 1/8 to 3/8 flat stock cutting? Would build a small 2x2 or 3x3 table.

jimcolt · #2 09-08-2010, 06:17 AM

While it will cut the 3/8" material, it may be a bit slow. You should have at least 45 amps if you are going to cut that thickness on a regular basis.

Jim

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
hypertherm 65/85	DanOSB	Hypertherm Plasma	3	08-19-2010 07:18 AM
Welcome to Hypertherm!	jimcolt	Hypertherm Plasma	0	12-16-2009 01:10 PM
hypertherm plasma cnc	woodman08	CNC Plasma and Waterjet Machines	6	12-15-2009 08:12 AM
Hypertherm 900	matttargett4	CNC Plasma and Waterjet Machines	4	11-24-2008 06:47 AM
Hypertherm or not ?	zeoncomp	CNC Plasma and Waterjet Machines	0	10-02-2007 10:40 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)