- Burning Countersunk Holes
-
Registered
Burning Countersunk Holes
Good day, I'm new to the site so hopefully this hasn't come up yet (I searched but could find no info). I'm wondering if anyone on here is burning counter sunk bolt holes, square or normal, with their Hypertherm powered 5 axis machines. The reason I ask is that we have a 5 axis table and we burn a lot of counter sunk square holes for plow bolts. It is very tricky as far as height control goes and 20% of the bevels for the counter sunk crash. I have talked to Hyperthem about the problems, but have not heard back from them or my table manufacturer. Just wondering if anyone has encountered these issues before. My apologies if this thread already exists.
Cheers!
Similar Threads:
-
- Burning Countersunk Holes
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules