My PMX65 is dead , what may cause the problem ?


Results 1 to 3 of 3

Thread: My PMX65 is dead , what may cause the problem ?

  1. #1
    Member
    Join Date
    Nov 2014
    Posts
    34
    Downloads
    0
    Uploads
    0

    Default My PMX65 is dead , what may cause the problem ?

    My PMX 65 stopped suddenly in the cutting process. Upon checking, Hypertherm technician informed to replace following items: 228707 IGBT 228659 Powerboard 228909 display module It is expensive repair so I must know the problem so I can avoid another problem. What is possible cause ?

    Similar Threads:


  2. #2
    Member
    Join Date
    Nov 2014
    Posts
    34
    Downloads
    0
    Uploads
    0

    Default Re: My PMX65 is dead , what may cause the problem ?

    It's been 3 days without anyone reply.

    I let the machine die, it is too expensive to repair if I don't know what the problem is.
    The problem may arise again in the near future.
    I am going to buy the replacement, shall I buy another brand or stick with Hypertherm ?



  3. #3
    Member
    Join Date
    Nov 2014
    Posts
    34
    Downloads
    0
    Uploads
    0

    Default Re: My PMX65 is dead , what may cause the problem ?

    Update: I bought chinese plasma cutter to replace the dead PM65, I use it it for 2 months now, the cut quality is not as good as hypetherm , but hey it cost less than half of repair cost , so I will not complain .



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

My PMX65 is dead , what may cause the problem ?

My PMX65 is dead , what may cause the problem ?