Post Processor Missing

[Jumbucks]

Sorry if I am asking a question answered elsewhere but still trying to work out where everything is on this site.

I was quite happily running AutoCAD mechanical Desktop 6 (I know it is old) with Hypermill V6 SP1. This was working fine until the hard disk crashed BIG time and I found out what parts of my system were not backed up!

To cut the long story short, I have got MTD6 back up and running, Hypermill is back and running and XLink is also running. What I am missing is the post processor files to glue it all back together.

Does anyone know where I can find these files? The machine is a Fanuc Mac-V3 and apparently uses a 6M post processor.

Any help appreciated.

JB

[BH Chia]

Hi JB, I am from OPEN MIND AP taking care of Australian market too. Pls send me know your requirement to my email address and I will try to help you.
boonhuat.chia@openmind-tech.com

Regards,

BH Chia