Hyd pump CB keeps tripping

Results 1 to 4 of 4

Thread: Hyd pump CB keeps tripping

  1. #1
    Registered
    Join Date
    Dec 2008
    Location
    USA
    Posts
    3
    Downloads
    0
    Uploads
    0

    Default Hyd pump CB keeps tripping

    I have a hydrulic pack that keeps tripping the breaker. The machine is a Daewoo Puma 200. Im not sure how to check to see if its a bad motor or a restriction in the system causing the pack to get very hot and then shut down.

    Thanks for any ideas

    Similar Threads:


  2. #2
    Community Moderator Al_The_Man's Avatar
    Join Date
    Dec 2003
    Location
    Canada
    Posts
    24216
    Downloads
    0
    Uploads
    0

    Default

    Measure current on all three phases for close match and no more than FLA marked on motor plate.
    If very unbalanced current then it could be the motor, if all phases the same then loading is most likely the cause.
    Al.

    CNC, Mechatronics Integration and Custom Machine Design

    “Logic will get you from A to B. Imagination will take you everywhere.”
    Albert E.


  3. #3
    Member
    Join Date
    Sep 2009
    Location
    usa
    Posts
    27
    Downloads
    0
    Uploads
    0

    Default Re: Hyd pump CB keeps tripping

    Another consideration to check as well is over time bi-metal type brakers that have heated up can alter there current carrying capability , making them trip at a lower amperage flow.
    A lot of machines came with this type of current protection.
    If your Full load amperage on all legs are close to each other and within your motors load specs and your not exceeding the capacity of the machine it would be something to look at.
    On some machines that don't have a dedicated motor braker but share all current loads through one primary braker then all electrical loads would have to be totaled to see if current exceeds the range of the braker.



  4. #4
    Community Moderator Al_The_Man's Avatar
    Join Date
    Dec 2003
    Location
    Canada
    Posts
    24216
    Downloads
    0
    Uploads
    0

    Default Re: Hyd pump CB keeps tripping

    Quote Originally Posted by big iron View Post
    Another consideration to check as well .
    Hopefully after 5yrs the OP has solved the problem!
    Al.

    CNC, Mechatronics Integration and Custom Machine Design

    “Logic will get you from A to B. Imagination will take you everywhere.”
    Albert E.


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Hyd pump CB keeps tripping

Hyd pump CB keeps tripping