| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| HURCO Discuss Hurco machines here. |
| | |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
01-28-2010, 08:54 PM
| |||
| |||
Found out there was a black tar like crud packed under some IC chips on my drive boards. Was able to tune them, except I can's make the z oscillate with the gain and it just has a load buzz. Any ideas? Also had a prox switch problem. The PLC thought the tool was clamped and unclamped all at the same time. Got the spindle to turn for the first time and turned the speed up with the rpm switch but it didn't seem to go faster. I might not have gotten the wheel around to the side with the red high speed writing. Anyway, when I turned the spindle off I got a motion error. Now the machine will not enable. I push the on botton and a relay clicks but as soon as i let off the relay lite goes off. I get no error only an emergency light on the PLC?????? I'm so close yet so far.  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 5AX 500 anyone running one? | BJ-DEKA | Bridgeport and Hardinge Mills | 0 | 12-27-2007 10:10 AM |
| Can't get EMC running | borrisl | LinuxCNC (formerly EMC2) | 2 | 08-18-2006 02:58 PM |
| Running an ATC | chrisw765 | Mach Software (ArtSoft software) | 6 | 11-08-2005 07:20 PM |
| Up and running | bob a job | Hobbycnc (Products) | 0 | 05-13-2005 04:26 PM |
| Up and running! | maxxgraphix | DIY-CNC Router Table Machines | 5 | 03-16-2005 07:10 AM |
| | |
Linear Mode
