Anybody know value of KMBX electronics? - CNCzone.com-The Largest Machinist Community on the net!

bmachinist · #1 12-07-2009, 09:40 AM

I have a KMB1 that works but I am getting tired of the programming. I am considering removing all the electronics except for the Freqrol spindle drive and servo motors. I would then sell (on eBay, US sales only) the surplus CMC servo drive (.0001"programing), emulator, DNC cable, and all the original electronics. Does anybody know what these are selling for? Thanks.

Hurco1 · #2 12-12-2009, 03:42 PM

Contact MartinCNC.com Shane deals with the older stuff and could give you a ballpark figure. Keep in mind the system is obsolete. Shane may even offer to buy the system boards. Who knows?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
tapping on a KMBX	bmachinist	HURCO	0	10-15-2007 08:00 PM
I need to know everything about CNC Electronics	alanfreefall	Servo Motors and Drives	10	07-19-2007 08:56 AM
Need MastercamX post processor for Hurco KMBX-1	zeeshan.insight	General CNC (Mill and Lathe) Control Software (NC)	0	05-17-2007 10:57 PM
Electronics	Bassbuilder	General Electronics Discussion	2	11-15-2004 09:34 PM
Electronics help	chuckknigh	DIY-CNC Router Table Machines	4	07-18-2003 09:09 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)