Hurco encoder glass disc - CNCzone.com-The Largest Machinist Community on the net!

Artty62 · #1 10-21-2009, 11:54 PM

Anybody have any encoder discs( had one break) that they would want to part with the encoder PN is #416-0248-010E. It has to be a .500 bore on the disc. PLMK if you have one and how much you want.
Regards,
Artty

Al_The_Man · #2 10-22-2009, 11:00 AM

I would think your best bet is try the encoder manuf. what is the resolution?
Renco have whole encoders with 1024p/rev with 1/2" dia disc for $90.00 on ebay, NOS.
If you can change the resolution, you could use one of these.
Al.

Artty62 · #3 10-22-2009, 11:12 AM

It's 200 line, I would prefer to use the original setup as I don't have a large working knowledge of Hurco system. I will eventually retro-fit this machine but don't have the cash right now.
Artty

thebodger@roger · #4 10-22-2009, 11:49 AM

You can probably get them from Midwest CNC, in Indianapolis.

Artty62 · #5 10-22-2009, 12:31 PM

I posted this thread before I called them they are searching for one now but I'm still looking till they get back to me.
Artty

bloke · #6 10-22-2009, 04:22 PM

We've got 8 of them in stock in the UK.

Artty62 · #7 10-22-2009, 11:11 PM

Thanks to all, Got one on the way from Midwest.
Artty

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Replacement Encoder Disc?	Jeshua	Servo Motors and Drives	18	11-25-2009 11:06 AM
I am using a DRO glass encoder for gecko 320	rokag3	Gecko Drives	5	03-12-2009 10:22 PM
Need Help!- How does a software disc...	IQChallenged	General CNC (Mill and Lathe) Control Software (NC)	25	10-28-2008 09:50 AM
Mounting rails on glass - how flat is glass?	Swiss	Linear and Rotary Motion	50	07-25-2008 03:10 AM
Disc Sander?	Zumba	General Metalwork Discussion	3	04-05-2006 10:33 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)