x axis ( direction change ) - CNCzone.com-The Largest Machinist Community on the net!

musnar · #1 10-14-2009, 11:17 AM

when i push the x(+) button it moves to (-) direction.
the other axis(z and y) dont have a problem.

what is the reason of this problem ? how can i fix it ?

SORCHEROR · #2 10-14-2009, 12:23 PM

you must have wired the x motor different,maybe couple wires switched
but just go into mach under motor reversal and reverse the x motor,easy fix

JWC · #3 10-14-2009, 04:45 PM

Check and or clean your main cable connectors to that axis

musnar · #4 10-15-2009, 03:42 AM

F4 SYSTEM CONFIGURATION
F4 DISPLAY MACHİNE CONFİGURATİON
ENTER
100
ENTER
F1 X AXIS
F1 INVERTED (not NORMAL MODE)

problem resolved, thank you all..

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
How do I change the direction of cut?	Ironworks	PlasmaCam	16	05-07-2009 11:53 PM
Need Help!- How To Change Direction on DC Servo?	parametric.ms	Servo Motors and Drives	32	09-16-2008 12:10 AM
i need to change the chucking direction !!!	miguisu	Fanuc	2	02-27-2007 11:46 AM
A axis direction change?	nervis1	Fadal	18	10-27-2006 11:49 AM
How cutting direction change	freesman	BobCad-Cam	6	07-28-2006 04:02 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)