Need Help! Maco B - CNCzone.com-The Largest Machinist Community on the net!

b.locke · #1 09-23-2009, 01:03 PM

I have a VMX24 with Ultimax and the NCPP option. When I run the following program

#600=0
#600=[#600+100]
M30

and I check #600 and it has a value of 200.
Anyone have a ideas on what could be causing this?

B

gthlm · #2 09-23-2009, 06:29 PM

Does it still do it if you remove the nesting? I can't see that it would make any difference but it is redundant in that case.

Gregor

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)