| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| HURCO Discuss Hurco machines here. |
| | |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#13
 
09-20-2009, 08:10 PM
| |||
| |||
| There is a key but I am not sure which way is unlock. There are 2 pictures of a grid. One has a line under it an the other an x with arrow heads across the grid. I assume that one means unlock. It does not seem to matter which way the key is turned - I see no difference on the screen plus manual mode works the same.  |
|
#14
09-21-2009, 07:54 AM
| |||
| |||
| Start from scratch. Power it up, wait until the screen has the config. page on it. Don't touch manual yet - it isn't time for that. If it just has the travel lengths and calibrate directions, press bottom softkey (exit) then type "enter" 999 "enter". The Input page should be displayed. Now press manual, power, start. Calibrate machine should be on the bottom softkey. |
|
#15
09-21-2009, 05:55 PM
| |||
| |||
| Still does not work - no calibration key... |
| Sponsored Links |
| |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Anyone Have a Hurco Tape Emulator/Hurco Tapes? | KyleH2 | HURCO | 2 | 01-05-2010 05:26 PM |
| MV-40B ATC dead | steelhead1 | Mori Mills | 1 | 06-09-2009 12:30 PM |
| Need Help!- Fanuc 0 dead screen ... dead control? | Noss Machine | Fanuc | 4 | 01-24-2009 09:03 AM |
| I think my X2 motor is about dead | BrassBuilder | Benchtop Machines | 6 | 03-19-2008 10:47 AM |
| Uh-oh, I think he is dead | kong | DIY-CNC Router Table Machines | 11 | 05-18-2004 06:20 AM |
| | |
Linear Mode
