Hurco PC Ultimax Version 1.4

[Cahill Tool]

Hi

I am looking for the software Hurco PC Ultimax Version 1.4 for my Hurco Hawk 5D Milling Machine which I have since 1994. I had the software on my computer and the computer has now died and the disks I have are damaged. I need this software urgently so please please can any help me.

Regards,

Barry

[JWC]

If the disk on the hard drive still turns, you might be able to plug it in as a slave on another system or as an external drive in a usb case. You can then use a data recovery program to pull it off the drive. There are many data recovery programs out there. I've had to do that a couple of times.

[Cahill Tool]

Hi JWC,

Thanks for the reply but the hard drive is not working either as we brought the hard drive to a computer repair shop and they told us that the hard drive was dead. We tried to upload the disks on another computer but the disks are damaged. Also we tried a program on another Hurco Mill and tried to download to the Hawk but this also did not work. Just to let you know I am not very good with computers.

[carpjimbo]

Barry,
I have just had a 1995 Hawk 5M installed with ultimax II version 1.4. It came with the config. floppy. I don't know if thats all you need but let me know and I should be able to make a copy
Regards

Jim