Need Help!- Hurco won't boot up

[bloke]

Do you have a keyboard to plug into the CPU?

[Dave Rothermel]

No. Is the cable something that I could fabricate?
Do you have any info on connections. What would I do
with a keyboard? Could I get into the bious setup. Could
I view it on the text crt?
Thanks again for your help.
Dave

[bloke]

You'd need a keyboard connected to re-load the software and/or manipulate files on the hard drive. Do you have an e-mail address?

[Dave Rothermel]

Yes i have an e-mail address.
k9dvl @ comcast.net

[Dave Rothermel]

Is there anybody that has a Schematic of the PC board, Max 32.
Dave

[Dave Rothermel]

When a Hurco Max 32 upgrade was done, Was it changing out the CPU board only? Is the personally board the same as Unimax ll? If i can't fix this KM3, I will half to retrofit it. Hobby CNC can't afford to replace boards at Ebay prices. Can't find any board info.
Dave

[bloke]

When the control is upgraded, there are some wiring changes in the console to allow for video through the pesonality card, a different EPROM in the CRT controller, an accelerator chip in the personality card, track modifications to the personality and dual axis cards and the CPU install. Other changes were to harnesses for the RS232, parallel port, A hard disk and snooper card and the floppy drive.