VM2 A.T.C. Error

[billiards]

Just wondered if anyone may notice these symptoms.

At tool change, ATC error shows on screen, usually with Tool pocket down. I go into diagnostics and put Tool pocket up, and then calibrate Tool carousel. But then when I try to change tools, you can hear the carousel moving around, but then nothing.

However, if I power down, and calbrate machine as normal, everything works again.

Obviously this fault is intermittent, and probably only occurs 4 to 5 times in an 8 hour shift.

[bloke]

What toolchanger error does it post? Where in the change does it stop? What's highlighted in the toolchanger diagnostic page?

[billiards]

Thanks for the reply......

Wouldn't you just know it! Didn't happen once today.

I will post the answers to your questions asap. Although I can answer one question. It stops after the tool pocket comes down with the next tool in it.