| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| HURCO Discuss Hurco machines here. |
| | |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
08-14-2009, 04:11 AM
| |||
| |||
Hello - This old hurco has been working good until today...after a few test pieces the xy & z axis would not move with the rapid buttons or the adjustment wheel. After a few seconds the emergence switch kicked in. I did hear some "crackling" sounds coming from the head, near the limit switches maybe (sounded like a possible short). Could a short up there cause all the axis to not work? I don't think my survos are powering up, but then again I am new to this machine. Any troubleshooting help is appricated. Thanks    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 4th axis Hurco | Paul Goddard | Mastercam | 8 | 11-22-2010 08:48 PM |
| New Hurco 5-Axis VMC | AppliedMachine | Product Announcements & Manufacturer News | 3 | 03-26-2010 06:46 PM |
| HELP! DeskCNC X-axis doesn't respond. | curtb | Mini Lathe | 2 | 04-21-2009 09:09 AM |
| Z axis bouncing on hurco sm-1 | jd-underdog | HURCO | 2 | 01-09-2008 10:27 AM |
| Looking at a Hurco 5-axis machine | Dan B | HURCO | 9 | 12-12-2005 11:13 AM |
| | |
Linear Mode
