cam software with hurco post processor

[Mag Man]

I just got a KM3P and am looking at software solutions. I got an older dos PC with it that will drip feed the mill. The guy I bought it from was using Surfcam and has a post for that, I am just looking to see if there is a more cost effective solution out there since this is sort of a hobby/toy thing.
Thanks
Mike

[GCMAN]

Check out gSimple. Its a free cam package. Looks fairly intuitive. Read the manual and see if it post to Hurco.
GC

[Rally]

I like VisualMill it cost effective and easy to use.
Works well with the Hurco.

[judleroy]

Just about all cam software will post to hurco. If it outputs basic nc them the hurco can read it. The file mask needs to be changed to .hnc. I know bobcad, mastercam, alphacam, even programs like stl.works can post to the hurco.

[Mag Man]

thanks guys I will give those a try, I just got the machines set up and running want to make some chips now