| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| HURCO Discuss Hurco machines here. |
| | |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
06-17-2009, 01:43 PM
| ||||
| ||||
MaxII setup. Which switch on the personality board turns off the speed controller so it becomes manual. Something has gone wrong and it the spindle goes to 500 rpm no matter what is programmed. I tried another personality board so that leaves the sensor on the spindle, wiring, or maybe dual axis board. I can manually increase it after it reaches the low rpm but it is getting to be a pain. I run mostly at 3000 rpm anyway so I just want to set it to manual. The board has two switch blocks. I have been told there is a board with 3.     |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Km3p | rkonnen | HURCO | 2 | 08-02-2009 09:54 AM |
| Need Help!- Hurco KM3P | ivanfed | HURCO | 0 | 04-20-2009 05:48 AM |
| Need Help!- KM3P will not move X+ | freak_brain | HURCO | 2 | 01-10-2009 10:38 AM |
| Need Help!- Newbie needs help with KM3P | freak_brain | HURCO | 8 | 12-28-2008 02:46 PM |
| Need Help!- KM3P CRT test | winds1sj | HURCO | 0 | 12-23-2008 11:15 AM |
| | |
Linear Mode
