| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| HURCO Discuss Hurco machines here. |
| | |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
05-07-2009, 10:35 PM
| |||
| |||
What is the correct way to tension drive belts on BMC-20 Hurco mill? Any help would be great. RoundieLand  |
|
#2
05-08-2009, 02:46 PM
| |||
| |||
| Only apply light pressure to the motor (a couple of pounds) whilst pinching the screws. Run the axis to let the belt centre itself then re-check the tension. Over-tensioning the belt will cause the motor shaft to wring off. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Direct Drive Vs Belt Drive for a Mill/Drill Retrofit? | pfeist | General Metal Working Machines | 11 | 02-13-2012 02:12 AM |
| Need Sherline Belt & qestion on X2 Belt Drive? | Oldboy | Benchtop Machines | 12 | 03-06-2008 12:42 AM |
| Belt Tension Options?? | flash319 | DIY-CNC Router Table Machines | 5 | 09-19-2007 02:06 PM |
| Timing belt tension requirements vs backlash | jensor | Mechanical Calculations/Engineering Design | 1 | 05-20-2007 02:04 PM |
| Belt Tension Adjuster Design | mxtras | Mechanical Calculations/Engineering Design | 8 | 05-16-2005 10:33 AM |
| | |
Linear Mode
