VMX64 - CNCzone.com-The Largest Machinist Community on the net!

Astrocncdept · #1 04-25-2009, 08:55 AM

So we just got in a used VMX64 and the chip convoyer dumps down real low onto the floor, does anyone know where I can get a cheaper but good secondary lift convoyer to dump into a 55 gallon drum? Hurco quoted me 8900, for one.

Brock_r · #2 05-01-2009, 12:11 PM

Try this link:

http://www.jorgensenconveyors.com/

or this one

http://www.barnesintl.com/content/

Have check book ready.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)