| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| HURCO Discuss Hurco machines here. |
| | |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
01-24-2009, 07:19 PM
| |||
| |||
I'm replacing the controller on my SM-1. I'm down to the amps I have figured our the wires that were used on J8, J9 and J10 connectors does anyone have the info on the two unused pins of these connectors and the info on J16. Any info on the LEDs on the front of the Axis cards? Amp # 002-1690-001 Donnie  |
|
#2
01-26-2009, 10:14 PM
| |||
| |||
| Any one have any ideal how Hurco disabled the amps other than kill the dc power and waiting on the Cap to bleed down? I first thought that J16 with two wires come off the up left side of the backplane was it but the white wire is ground potional and the blue is 10 volts short it to the white wire and it kills the amps for about 2 seconds and then the amp re-enable. Donnie |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cleaning Fanuc Power supplies, Servo amps? | FanucIssues | Fanuc | 4 | 06-07-2007 02:43 PM |
| Wanted A/C servo amps & motors | Bap | Servo Motors and Drives | 1 | 05-13-2007 12:23 PM |
| older Brush Servo amps | miljnor | Haas Mills | 2 | 02-18-2006 09:06 PM |
| Howto find input amps, from output amps on transformer? | sendkeys | General Electronics Discussion | 7 | 07-14-2004 07:13 PM |
| DC servo amps | converterk | CamSoft Products | 1 | 12-21-2003 11:09 PM |
| | |
Linear Mode
