Hurco MD1 Ultimax 2 control lockup

[rallyslag]

Hi i recently acquired an MD1 Hurco

we installed it and got it running yesterday and was running some small test programs and changing tools all fine

it would appear that the machine has developed a fault when i switched it back on today the system boots to the main page
but wont respond to any control inputs is this a common fault with the control ?

would like advice as in either repairing the existing control or obtaining a wiring diagram for the machine to retrofit a new control in its place (EMC2)


Thanks

[bloke]

Replace U14 & U15 on the CPU (MC1488 & MC1489), replace the MC1488 & MC1489 on the CRT controller and also the P8255A on the CRT controller.

[rallyslag]

Thanks for the info

What is it these parts do ?

are they all in the main computer cradle in the rear cabinet ?


thanks

-Colin

[bloke]

The CPU is in the rear cabinet, the CRT controller is in the console.

[rallyslag]

ok thanks

iv found the parts on eBay hopefully it will solve the problem

is the P8255A replaceable with P8255A-5?

[bloke]

Not tried it but it should be ok.
You could also use an Intel P82C55A2 or an NEC D71055C-10

[rallyslag]

I did as you suggested but is hasn't cured the problem, is there anything else i can try ?

[bloke]

Not without a few boards to try swapping. Where are ya in blighty?

[rallyslag]

Brackley, Northamptonshire

its near to silverstone race track


i do have a spare hurco computer but i cant gaurantee the state of that one as i stripped that for mechanical spares due to faulty memory boads

[Frenchman]

When you say it boots to the main screen. Is this the configuration screen (where it shows the machine travel limits) or will it exit to the main input screen?
If it is on the config screen, are the displayed values in Metric or English?

If in Metric then press the bottom softkey, press enter button, press 999, then press enter button again. then select exit (Bottom softkey).
Control should reboot and display english values for travels.

Goodluck

[rallyslag]

yes stuck on the config screen

its displaying limits in inches

and softkey is unresponsive

[JWC]

Originally Posted by rallyslag yes stuck on the config screen its displaying limits in inches and softkey is unresponsive

turn the main power off then back on. When the config screen comes up, hit ENTER 999 Enter and see if that works

If in inches- hit the bottom softkey between the monitors, in some versions of the software, the exit is not visibly listed