vmx 24 warm up cycle time

[isar]

hi there

when we went to a hurco demo we was shown a vm1 and was shown an option to change warm up cycle time.. yesterday we had an vmx 24 installed but cant seem to find the option to change warm up cycle time..any one know where it is?

many thanks

[bloke]

Should be in the manual parameter setup pages.

[frenchy313]

If it's Winmax you should be able to go to aux, user preferences, machine parameters; and it's page 4. depending on which software version you have you should be able to change it there. If not you would have to go into integrator support services and change it in the N95 section. Hope this helps.

[isar]

thanks.. we found it on page 4 but when we put new settings in and exit machine parameters and go back into page 4 it has gone back to old setingsany idea?

[frenchy313]

Yeah, you must have a newer version of winmax, Go aux, utilities, integrator support services, enter 46268 for password, integrator support services, N95 and page down until you come to warm up cycle and you should be able to change the rpms. hurco recommends not going over 3500 rpm without a tool in spindle. Especially without a chiller. Make sure to make a backup config disk. You can make one by going to aux, utilities, system config, back up config to disk, and save the disk in the back cabinet just in case. Hope this helps...