Problem Ultimax3 Disk Failed - CNCzone.com-The Largest Machinist Community on the net!

musnar · #1 05-28-2008, 11:27 AM

hi all,

My machine Hurco BMC-30 ultimax3 (1994)

error message: >> disk sub-system failed to initialize

What must i do..

RON MEYER · #2 06-03-2008, 07:41 PM

this could be caused by a bad floppy, bad hd, or drive controller on the cpu. try a new floppy first. standard 1.44 floppy. make sure no one has had their hands in the console or card rack moving cables. if your machine has the original executive disks in the back cabinet, you can boot the machine off of those disks. the machine will not run at that point, but you can then go to auxillary and select the upgrade master. the disks can then be loaded as an upgrade. if the machine will not boot off of the executive disks, then one of the above is bad.

ron meyer

bloke · #3 06-22-2008, 10:26 AM

Are you in Eskisehir?

musnar · #4 07-06-2008, 12:59 PM

Thank you, ron
Im in istanbul, bloke

epron .BIN file failed.. reloaded BIN file and it is resolved problem.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Tried to buy a HF X2 yesterday. Failed!	tooManyHobbies	Benchtop Machines	8	03-11-2008 06:00 PM
BMC20-Ultimax3	stevieboy	HURCO	1	08-28-2007 04:49 PM
X axis transistor failed...AGAIN	Mr. Technical	Bridgeport and Hardinge Mills	18	08-21-2007 06:16 PM
Boolean difference failed	chetosmachine	Rhino 3D	8	06-12-2007 05:24 PM
Failed transformers?	Jetlag	General Electronics Discussion	2	09-09-2005 02:50 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)