Hurco board @ CRT needed

[Mr. LocoMartin]

This Hurco I'm looking to pick up has issues.
So far I need a CRT And a CRT controller board.

[123CNC]

I'm probably going to throw a couple of my Hurco KM3 Ultimax II items on e-Bay in the near future. My main board and RS232 board lost their magic smoke, so I plan on upgrading to a cheaper maintainable controller. I'll probably let most of the manuals go as well.

Send me a PM if you have the board PNs and I'll let you know if I got anything that might help ya.

[Mr. LocoMartin]

I need a crt screen & I need the board that lies inside the input panel, at the very back. it's the board which has the 8 pin dip switch on it.
let me know and thanks for the reply.
Take care,
Martin

[Mr. LocoMartin]

I don't know if I was able to send off a reply from my pocket pc or not, so here it is again.
I need the text CRT which is the one on the left hand side of the control panel.
I don't have a manual...yet.
But the CRT Controller board is located under the key pad panel at the very back of the housing. It's the only board with dip switches on it.
Can you give me an idea what you would like to get for the parts ?
I have a repairman coming to fully diagnose this gem.
Thanks in advance.
Martin
330-389-1091

[123CNC]

Locomartin,

I sent you a PM. I will get back to you later today after visually verifying the board is there.

[ov1mohawk]

Did you ever find the parts you needed? If not let me know I have the whole unit that I pulled off mine when I converted it.

Jeff

[thebodger@roger]

Did you try dave at Midwest CNC? I have no affiliation to them, but I buy my hurco parts from them. They a very reasonable cost wise, and are excellent tech support. A great bunch to deal with