| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| HURCO Discuss Hurco machines here. |
| | |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
01-07-2008, 10:06 AM
| |||
| |||
I have a hurco sm-1 mill and i am having trouble with the z axis, before and after it makes a cut the head seems to bounce quite a bit, sometimes it will even throw a motion senser and shut down the machine, anybody have any ideas for a fix? Im was told it is probably the board, i have already replaced the z motor, it has new brushes, and i put a new ribbon cord in the boards any ideas?  |
|
#2
01-07-2008, 09:22 PM
| |||
| |||
| Since you have swapped out the motor you have ruled out the encoder. Most likely the board, but I would also swap out cable assembly between the Z axis motor and the control box with one of the other ones. If you are lucky, it might be a cable/connector problem. Is this a B or BX control? |
|
#3
01-09-2008, 09:27 AM
| |||
| |||
its a bx control |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| HURCO BMC 20 | PCM | HURCO | 4 | 03-30-2008 07:11 AM |
| Spindle bouncing up an down | mattinaustin | Industrial Hobbies (Support forum) | 5 | 02-26-2007 10:03 AM |
| Hurco vmx42 4th axis | lab73 | Post Processors for MC | 1 | 02-24-2007 10:34 AM |
| hurco km-1 Z axis drive ? | D.D.Machine | HURCO | 0 | 01-10-2007 07:19 PM |
| Looking at a Hurco 5-axis machine | Dan B | HURCO | 9 | 12-12-2005 10:13 AM |
| | |
Linear Mode
