Hurco bmc external device HELP

[tecko]

Hi

I want to connect a haas external Indexer, to a Hurco BMC 50 with a max 32 control. Anybody any suggestions. I think the code is m54.. So question 1. What 2cable's tell the indexer to run and 2. What 2 cable's tell the machine it has finished its cycle

Thanks
Pat

[Al_The_Man]

I don't have the details of your machine, but I can give you an idea what happens in most cases of this type of hook-up.
If your control does indeed have a M54 set for this purpose, and it does wait for a finished signal from the indexer, then if you issue a M54 in say MDI, it should hang there and not complete, in the absence of documentation, using this you can find out what phyisical output comes on, either on the output module or card, or in the diagnostic page, (I/O) depending on the system.
The catch now is to find out what input they use for the finish sig.
The easiest way is if you have the I/O listing and schematics for the machine,
once the I/O is found, the signals of the indexer have to conform to the type of I/O you have, i.e. relay or solid state, transistor sink/source etc.
If you have an output card that has LED's on it, the appropriate one will light when the M54 is output.
Hope this helps.
Al.

[RON MEYER]

have you got your indexer hooked up to the indexer port? do you have the manual for your machine? it will show the proper pinout. if you don't have the manual, i do. it's about 10mb in pdf. have you got an e-mail account that can accept that size of file? the manual gives you all need to know. ron

[tecko]

yes Ron its john@mtil.net .. I havnt got the manual customer lost it it would be great if you could e-mail it to me

Thanks pat

[wynmachines]

hey....this gagan from india.
i had hurco bmc-20 but i dont have its manuals..
so will you please send me manuals at wynmachines@gmail.com

thanx for your upcoming help!

bst regards,

gagan