Need Help! I have a problem with my VM1 Hurco machine

Results 1 to 7 of 7

Thread: I have a problem with my VM1 Hurco machine

  1. #1
    Registered antoniomasat's Avatar
    Join Date
    Feb 2016
    Location
    Torreon
    Posts
    9
    Downloads
    0
    Uploads
    0

    Default I have a problem with my VM1 Hurco machine

    I had the battery fail CMOS problem and the CMOS Checksum error, I'd replace the RTC battery with the Dallas module replacement and the battery alarms dissapear, I can modify the BIOS setting, but now I have this problem the machine stay in this message Verifying DMI Pool Data and don't start, I have several floppy disks, but I don`t have the manual to know how restore the complete system.

    Someone could help me please?

    I need to restore all system or I can save the original hard disk?

    Thanks in advance for your help!

    Similar Threads:


  2. #2
    Registered
    Join Date
    Jun 2008
    Location
    England
    Posts
    954
    Downloads
    0
    Uploads
    0

    Default Re: I have a problem with my VM1 Hurco machine

    Sounds like you have the wrong CMOS settings for the hard disk. What did you set it as?



  3. #3
    Registered antoniomasat's Avatar
    Join Date
    Feb 2016
    Location
    Torreon
    Posts
    9
    Downloads
    0
    Uploads
    0

    Default Re: I have a problem with my VM1 Hurco machine

    I'd only change the boot sequence, starts with C, same fail, starts with D same fails, exists more settings to do?



  4. #4
    Registered
    Join Date
    Jun 2008
    Location
    England
    Posts
    954
    Downloads
    0
    Uploads
    0

    Default Re: I have a problem with my VM1 Hurco machine

    What are the hard drive settings?
    Cylinders, heads, sectors?
    LBA?



  5. #5
    Registered antoniomasat's Avatar
    Join Date
    Feb 2016
    Location
    Torreon
    Posts
    9
    Downloads
    0
    Uploads
    0

    Default Re: I have a problem with my VM1 Hurco machine

    ahh, it's in auto detection mode, but they are LBA 117, 231, 408, 60GB M5_P1



  6. #6
    Registered
    Join Date
    Jun 2008
    Location
    England
    Posts
    954
    Downloads
    0
    Uploads
    0

    Default Re: I have a problem with my VM1 Hurco machine

    Set them in CHS
    3303 cyl
    16 heads
    Wpcom 65535
    lzone 0
    63 sectors

    Then change to LBA



  7. #7
    Registered antoniomasat's Avatar
    Join Date
    Feb 2016
    Location
    Torreon
    Posts
    9
    Downloads
    0
    Uploads
    0

    Default Re: I have a problem with my VM1 Hurco machine

    Ok I'll try it, thanks for your help!



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

I have a problem with my VM1 Hurco machine
I have a problem with my VM1 Hurco machine