I have a problem with my VM1 Hurco machine

[antoniomasat]

I had the battery fail CMOS problem and the CMOS Checksum error, I'd replace the RTC battery with the Dallas module replacement and the battery alarms dissapear, I can modify the BIOS setting, but now I have this problem the machine stay in this message Verifying DMI Pool Data and don't start, I have several floppy disks, but I don`t have the manual to know how restore the complete system.

Someone could help me please?

I need to restore all system or I can save the original hard disk?

Thanks in advance for your help!

Similar Threads:

• Need Help!- Hurco BMC 30 problem
• Problem- G42 Hurco problem
• hurco km3 problem
• HURCO ATC problem

[bloke]

Sounds like you have the wrong CMOS settings for the hard disk. What did you set it as?

[antoniomasat]

I'd only change the boot sequence, starts with C, same fail, starts with D same fails, exists more settings to do?

[bloke]

What are the hard drive settings?
Cylinders, heads, sectors?
LBA?

[antoniomasat]

ahh, it's in auto detection mode, but they are LBA 117, 231, 408, 60GB M5_P1

[bloke]

Set them in CHS
3303 cyl
16 heads
Wpcom 65535
lzone 0
63 sectors

Then change to LBA

[antoniomasat]

Ok I'll try it, thanks for your help!