- KMB1
-
Registered
KMB1
Hello
I have a Hurko KMB1 and the engine zero point we did not finish, it drives the switch reacts also then drives 25 mm back in x and y but does not take that.
can someone help me or say why it is in z he does it
Kind regards
Eddy
Similar Threads:
-
-
Registered
Re: KMB1
Are you talking of homing the machine? the machine needs to hit the limits, then back off until they deactivate, then from there the control will know the machine is at limit and bases its travel off that position. This is just what Ive found on my KMB-1, and i am no tech by any means. Elaborate more please?
-
Member
Re: KMB1
Axis balance is off. Put a digital voltmeter on DC volts between the orange and brown wires on the edge of the Randtronics servo amp for each axis just after powering up the servos (before table zero). Adjust Bal pot on the axis being measured to get 0v
- KMB1
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules