KMB1

Results 1 to 3 of 3

Thread: KMB1

  1. #1
    Registered
    Join Date
    Sep 2017
    Location
    Germany
    Posts
    3
    Downloads
    0
    Uploads
    0

    Default KMB1

    Hello
    I have a Hurko KMB1 and the engine zero point we did not finish, it drives the switch reacts also then drives 25 mm back in x and y but does not take that.
    can someone help me or say why it is in z he does it
    Kind regards
    Eddy

    Similar Threads:


  2. #2
    Registered
    Join Date
    Nov 2017
    Location
    United States
    Posts
    3
    Downloads
    0
    Uploads
    0

    Default Re: KMB1

    Are you talking of homing the machine? the machine needs to hit the limits, then back off until they deactivate, then from there the control will know the machine is at limit and bases its travel off that position. This is just what Ive found on my KMB-1, and i am no tech by any means. Elaborate more please?



  3. #3
    Member
    Join Date
    Jun 2008
    Location
    England
    Posts
    1103
    Downloads
    0
    Uploads
    0

    Default Re: KMB1

    Axis balance is off. Put a digital voltmeter on DC volts between the orange and brown wires on the edge of the Randtronics servo amp for each axis just after powering up the servos (before table zero). Adjust Bal pot on the axis being measured to get 0v



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

KMB1

KMB1