KMB-1 Relay Control Signals

[DRobs86]

Does anyone know what control signals are required on which terminals to activate the relays on the KMB1?

I'm doing a conversion with the KFLOP and KANALOG and am having trouble tracking down anything beyond a cursory schematic of what is connected.

Similar Threads:

• Shielded Wire for Control Signals?
• Need Help!- Design a control circuit of DC motors using pic by Step & Dir signals
• Single signals to Differential signals - best methods ?
• What control signals are sent to the servo amplifiers?
• To convert Quadrature Encoder signals to Tachogenerator signals

[GT390]

When I converted my KMB1 I found it much easier to ditch the original relays and use SSR type, they can be switched with the low output directly from my PMDX 126 break out board, this made it very simple and no need for transformer to get the correct voltage to operate the original relays which from memory I think was 24v
I think your Kanalog will have the same ability to directy switch a SSR (solid state relay)
Rob