Need Help! "power cabinet temp too high"

Results 1 to 3 of 3

Thread: "power cabinet temp too high"

  1. #1
    Registered
    Join Date
    Feb 2017
    Location
    Pakistan
    Posts
    3
    Downloads
    0
    Uploads
    0

    Default "power cabinet temp too high"

    i am using hurco hawk 5m ultimax3 its show error "power cabinet temp too high enter machine diagnostic" i need help how resolve this problem.

    Similar Threads:


  2. #2
    Member
    Join Date
    Oct 2004
    Location
    usa
    Posts
    188
    Downloads
    0
    Uploads
    0

    Default Re: "power cabinet temp too high"

    check the power supply voltages. sounds like low voltage there should be test points on the rack -12, 5, 12, 24vdc. the 5 volt rail should be 5.10
    if they are all good, then try the oldie but goodie pull the cards clean the connections and put it back together.



  3. #3
    Registered
    Join Date
    Feb 2017
    Location
    Pakistan
    Posts
    3
    Downloads
    0
    Uploads
    0

    Default Re: "power cabinet temp too high"

    Thanks for reply i already check all voltage of supply fans are running and card put different slot but result is same.



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

"power cabinet temp too high"

"power cabinet temp too high"