- Need Help!- Hurco bmc2416/dsm atc error
-
Registered
Hurco bmc2416/dsm atc error
Hy. how to adjustment of atc height?
Thanks
Similar Threads:
-
-
Member
Re: Hurco bmc2416/dsm atc error
If version 2 software, Auxiliary enter 100 enter to get to service page. Go to machine setup then go to toolchanger diagnostics. Press more key until store t/c height is displayed then press when at the correct height to store it.
-
Registered
Re: Hurco bmc2416/dsm atc error
step by step be? It failed to enter on this basis:ADJUSTMENT OF ATC HEIGHT
ULTIMAX II, 32, ULTIMAX 3 MB MACHINING CENTERS
MAX2 8.50 to 8.6 & MAX3 SOFTWARE
Problem description:
Tool changer not at correct height.
1. Calibrate Axis and Tool changer. Orient Spindle. Set Current Tool to "0". Start ATC Diagnostics (this is done in Manual Mode) by depressing ATC Diagnostics Softkey, then depress Machine Diagnostics Softkey.
2. Ensure Z Axis is fully Calibrated, then depress the Magazine Right Softkey then Start button. Next you will enter the "Secret Code". Do this by pressing "Enter, 1,0,1, Enter ". Carefully jog the Z axis down with the Jog Hand Wheel, to obtain .5" between the bottom of the "V" Flange located on the Tool Grippers and the bottom of the spindle nose. Refer to figure below
3. The CRT displays Z Axis position, i.e.; (Z Axis) 0.0000 (TARGET) 0.0000. Target is previous value if any. Press Store Z Softkey. This records the Z Axis's present position as the new Tool Change Height. Check at this point that (Z AXIS) equals (TARGET) and AT HEIGHT is back lit. Press Exit Softkey.
4. To test your adjustments, jog head up and move magazine to the left. Place tool into spindle. Now jog Z Axis down until "AT HEIGHT" is back lit, then move magazine to the right. Watch for smooth engagement of tool changer and tool. If tool magazine wants to move up or down adjust Target Value as described above.
5. Record value in "TARGET" for future reference.
6. Run Tool Changer in auto mode to test operation.
-
Member
Re: Hurco bmc2416/dsm atc error
That is the description for Max 2. We didn't do a 2416 before Max 3.
-
Registered
Re: Hurco bmc2416/dsm atc error
Unfortunately, as it turned out it was built machine.plc loose
-
Registered
Re: Hurco bmc2416/dsm atc error
Hy Auxiliary enter 103 enter.
-
Member
Re: Hurco bmc2416/dsm atc error
Maybe some one have 2.16 software for hurco 2416, i can share i have older soft 2.15 in that no industry standart
- Need Help!- Hurco bmc2416/dsm atc error
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules