- Posting from esprit cam to a hurco VMC
-
Registered
Posting from esprit cam to a hurco VMC
Hi, I work for a small machine shop that just purchased esprit cam. I need some help getting NC code into our Hurco's.
We have been able to post programs out to our Mazak turning center. But we have had no luck with posting to our Hurco's (vm20i, vm10).
Is there a tutorial somewhere, or some advise?
Esprit has given us the latest post processors for our machines. We have tried running the code that Esprit generates with no luck, the hurco just says unknown g code.
Does running NC code use the same tool library that the winmax conversational programs use? Is there anything else that needs to be set up for this to work properly?
Similar Threads:
-
-
Member
Re: Posting from esprit cam to a hurco VMC
Make sure you are using Industry Standard NC on the Hurco instead of Basic NC. Or vice-versa if your post is set up for basic.
-
Registered
Re: Posting from esprit cam to a hurco VMC
I am fairly certain the post is set up for industry standard. I know the hurco is.
I will double check that.
I will try and get a picture of the code, and the errors that I am getting.
Thanks
- Posting from esprit cam to a hurco VMC
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules