VSX 24 Axis problem

[hurcouser1]

Hi all,

I have a problem when i boot up the machine. Its not finding the axis.

When its booted up it says no axis was specified for servo command.

I have the diskette book, would booting up the mc with one of these disks sort out this problem? and if so which one?

Or any other suggestions?

Thanks in advance,

Nick.

[faja]

Hi

I think that parameters and MCD files are wrong. Try find Configuration Backup Diskette an use it using Auxiliary -> System COnfiguration -> Restore Confing. Then ReBoot.

Good luck

[hurcouser1]

That worked, fixed the problem. Thanks a lot, much appreciated