following error on x axis

[frogstar]

hiya
this is all a bit new to me so here goes..
I have got a Hurco hawk 5 ssm witch i have used for the last 5 years or so and has benn a good machine up untill now.I keep getting a following error on axis x and cant find what has gone wrong. i have swapped the x and y servo motors over and still following error on x. also checked the wires individualy for breaks. they seem ok. ive swapped the x and y axis boards over and still the error on x anyone help me ? pllleeeaaase

[xray34]

hiya
this is all a bit new to me so here goes..
I have got a Hurco hawk 5 ssm witch i have used for the last 5 years or so and has benn a good machine up untill now.I keep getting a following error on axis x and cant find what has gone wrong. i have swapped the x and y servo motors over and still following error on x. also checked the wires individualy for breaks. they seem ok. ive swapped the x and y axis boards over and still the error on x anyone help me ? pllleeeaaase

If its any help I had the same error on My Hurco Hawk 5 Ultimax 3
turned out to be the Honda breakout board was knackered.
Mine it was on the 'A' Axis.. but I believe they use the same boards..

[frogstar]

If its any help I had the same error on My Hurco Hawk 5 Ultimax 3
turned out to be the Honda breakout board was knackered.
Mine it was on the 'A' Axis.. but I believe they use the same boards..

thanx for the reply but i have swapped the boards and still get the same error on x thanx any way much appreceated

[judleroy]

See if the limit switch is stuck. If so clean it without removing it if you can. Good luck.
Judleroy