Hey all, I am trying to connect a Hurco VMX 50S using the Ultimax controller to a workstation. It was hooked up just fine a while back, but our company has moved and all settings were reset. The computer we use to program is only hooked to the Hurco via Ethernet (not on a network with others) and the program being used is ws_ftp pro. Now I am able to get the computer to see the Hurco, but it cannot establish a connection and says the usual "limited or no connectivity" on the network. What I need to know is what settings would I require to get this running again? I'm guessing this is related to an IP address issue? Also, would it be possible to hook the computer to a wireless network and keep it wired to the Hurco? It was hooked up like this once before but the Hurco did not like sharing the network.