Hurco KMSP Problem

[Port N Polish]

Gi-Day Lads. I have a 1996 Hurco KMSP Mill with Ultimax SSM. I was making a cut on a cylinder head and it shut down and showed X,Y,Z, axis limit switch, spindle overtemp, motion control error. I turned it off for the weekend. When I turned it on next it loads EXEC. program etc. and gets into manual mode. The power push button clicks but it doesn't light up or turn on the axis mode cycle switch doesn't do anything either. I re-seated boards and plug-ins in main cabinet and control cabinet. What do I need to try next? Thanks.

[bloke]

Check the power supply is giving out 24v. If it has the separate gold power supply, measure it using the DC volts setting on your meter between the blue and grey wires.
If it has the supply on the side of the card rack, take off the top cover and measure the two outermost test points on the little board just inside the cover.

[Port N Polish]

Gi-Day Lads. Hey Bloke thanks for the input, I did what you said and I'm getting 24v. I took it one step further, I'm getting 24v at the pinout in the control console. There is a green LED on the interface board that flashes. What does this mean? On the push button board the printed circuit near the start switch reads 5.13v at location 1p6. Can I check for push button voltage at the control relay board. (Is this where the "power on" voltage goes?) Thanks.