Hurco VM10U w/WinMax 8 -- Need Mastercam X4MU3 Post Processor

[bcdebusk]

I have a VM10U w/WinMax 8. I'm using ISO standard C axis and absolute tool length measurement.

Does anyone have a post processor that will work with MasterCam X4MU3?

In-house solutions has been screwing-up my post for six weeks now. I'm about to give up.

What's up with Mastercam and post processors anyway? It's always a nightmare.

[Shane123]

i use a post processor i found on this site. used it with x2 and now x3. My machine is the vmx42. it works slick for the most part, could tweak it just a little to my personal likings but its not needed. the one from our vendor kept wanting to drill up, as well as a few other issues...

[bcdebusk]

i use a post processor i found on this site. used it with x2 and now x3. My machine is the vmx42. it works slick for the most part, could tweak it just a little to my personal likings but its not needed. the one from our vendor kept wanting to drill up, as well as a few other issues...

Is that a vector post? I thought a VMX42 was a B-C table and I have an A-C table. Are they compatible?

[Shane123]

dont know, sorry.

[Brock_r]

Contact Hurco APplications Support, they should be able to assist in this effort.

317-293-5309