Need Help!- HURCO 5 AXIS

[RICK B.]

WE HAVE A NEW 5 AXIS HURCO, WE USE SURFCAM VEL 5.

DOES ANYONE HAVE A SAMPLE PROGRAM FOR DRILLING 2 HOLES ON THE SIDE OF A PART B-90?? ALSO A SAMPLE PROGRAM FOR FULL 5 AXIS RUN.

THANK YOU RICK B

[Tribor]

Hello,

Is there a G-code or any command which send the tool a reference point in the Hurco Ultimax 4?
Similar to the Fanuc's G28. I want to use it before the 5axis table indexing.

Regards,

Tibi

[glovebox20]

Originally Posted by Tribor Hello, Is there a G-code or any command which send the tool a reference point in the Hurco Ultimax 4? Similar to the Fanuc's G28. I want to use it before the 5axis table indexing. Regards, Tibi

Tibi

Try using a M25 on a line by it self. I believe this will send the Z Axis to home position, although it may cause the spindle to orientate at the same time. Can't remember off the top of my head. I'll check the Ultimax 4 manual when I get a chance.

[glovebox20]

Originally Posted by RICK B. WE HAVE A NEW 5 AXIS HURCO, WE USE SURFCAM VEL 5. DOES ANYONE HAVE A SAMPLE PROGRAM FOR DRILLING 2 HOLES ON THE SIDE OF A PART B-90?? ALSO A SAMPLE PROGRAM FOR FULL 5 AXIS RUN. THANK YOU RICK B

Rick

Did you try contacting customer support at Hurco's web site? http://www.hurco.com/USA/Support/Pag...coSupport.aspx
Or your local Hurco Seller?

I would love to help out, but I lack the machine and the experience to try it out on.

glovebox 20

[Tribor]

Originally Posted by glovebox20 Tibi Try using a M25 on a line by it self. I believe this will send the Z Axis to home position, although it may cause the spindle to orientate at the same time. Can't remember off the top of my head. I'll check the Ultimax 4 manual when I get a chance.

THX!
Regards,
Tibi

[Jimp178]

Hi Rick

What model of Hurco do you have.
We have just purchased a VMX60SR

I am using Mastercam to program still having probs with the post.

Jim

Bonnie Scotland

[hurconotes]

There are special G Codes for Transfern Part Plane...

I think they are G68.2.... you would need to position first than call it up...

[Tribor]

Hi,
Yes there are some spec G-code. I have a five 5axis Hurco manual for CAM post's. I upload it today.
We try these g-codes but not work fine. I think we made some thing wrong.
Has anybody a 5 axis NC code which work fine?
I need only 5ax indexing.

Regards,
Tibi

Originally Posted by hurconotes There are special G Codes for Transfern Part Plane... I think they are G68.2.... you would need to position first than call it up...