BMC 30 / Ultimax 3 Replacement Monitors

[TZak]

I have a BMC 30 with an Ultimax 3 controller. Both colour displays have burnt out. I would like to replace them with either a LCD or some old crt computer monitors that I have. I am trying to find what type of connector and the pins-out are to make a jumper cable going from a standard VGA monitor connector to the controller. Please see attached images of the connector on the controller.

Any help would be appreciated.

[bloke]

10-way cable pins are as follows:
1 red video
2 red video ground
3 green video
4 green video ground
5 blue video
6 blue video ground
7 horizontal sync
8 horizontal sync ground
9 vertical sync
10 vertical sync ground

12v power can be sourced at the J3 & J4 connectors (where the 24v is wired to for the old monitors) but on the following pins:
J3 pin 4 (12v)
J3 pin 5 (0v)
J4 pin 4 (12v)
J4 pin 5 (0v)

[TZak]

Just another quick question. Do you have any idea what the connectors they use are (P/N or TYPE)? Or would you recommend just cutting the connector off and making a new cable?
Thanks

[judleroy]

On my bmc 30 ultimax 3 machine there are regular monitor cables coming from the controller. They are behind the big board in the console at the back under the moniters.
Not sure if yours is the same as mine? good luck

[bloke]

I'd just nip the connector off and solder on a new 15 pin D-type. Heatshrink the little shield wires though.