| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| HURCO Discuss Hurco machines here. |
| | |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
04-25-2010, 07:19 AM
| |||
| |||
Does any one have a procedure to tune in a replacement Yaskawa servo drive for a BMC 20 to match the speed of the other 2 older drives? I recently replaced a drive and when I cut a circle I get more of an egg shape.  |
|
#2
04-25-2010, 10:34 AM
| |||
| |||
| Check the jumpers are set the same as the X or Y depending on which amp you have changed. Roughly set the pots to the same settings (VR1, VR4 & Zero. Avoid moving pots that have been paint-marked. Jog the axis (or write a program) to be set up at 1016mm/min (40 IPM). Connect a voltmeter with the positive lead on TM3 pin 2 on the servopack and the negative lead on the 0v terminal. Adjust VR1 (coarse adjust)first and VR4 (fine adjust) after to get 0.95v DC both ways (use the Zero pot to make the forward reading match the reverse). Check the other amps to ensure they are set correctly too. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Help!- adding 4th axis: need to match existing servo? | BiggerHammer | General Electronics Discussion | 0 | 01-13-2010 06:35 PM |
| Newbie- How do I choose a servo to match my current setup? | BiggerHammer | Servo Motors and Drives | 4 | 01-12-2010 10:01 AM |
| Newbie- Question aboout motor/drive match | Thomasdj | Servo Motors and Drives | 1 | 10-05-2009 04:46 AM |
| Tuning a G340 servo drive | chas | Gecko Drives | 1 | 04-07-2005 07:15 AM |
| Anyone with experience tuning a Compax servo drive? | ESjaavik | Servo Motors and Drives | 0 | 08-13-2004 06:33 PM |
| | |
Linear Mode
