| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Hobbycnc (Products) Discuss Hobbycnc controller boards here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
06-28-2009, 08:08 PM
| |||
| |||
Hi, can anybobody tell me the voltage of the driver board on the Hobby Pro board, on TB 6 I have 33.6 volts. And the way to check this is by putting the black lead of the volt meter on the Com terminal and the other on B, b, a, A ? B= b= Com a= A= Thank you  |
|
#2
07-03-2009, 01:09 AM
| |||
| |||
| Hi, maybe I will ask my question in another way, is there anybody that is using the recommended transformer(Triad 24 volt 10 amps) if so what kind of voltage are you getting on TB6 and on the drivers output? B= b= Com a= A= Thank you |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Able to run motor with higher voltage driver? | Syphonics | General Electronics Discussion | 2 | 04-21-2009 08:49 PM |
| Driver voltage selection for known DC motor. | bunalmis | Servo Motors and Drives | 1 | 11-07-2006 09:09 PM |
| what voltage? i'm confused.. Stepper motors + driver board from hobbycnc | Loterus | Hobbycnc (Products) | 8 | 01-26-2005 07:10 AM |
| Picstep board voltage question | dberndt | Stepper Motors and Drives | 1 | 01-15-2005 10:34 PM |
| Excess voltage to servo driver board | Splint | General Electronics Discussion | 4 | 04-27-2004 03:46 AM |
| | |
Linear Mode
