Newbie Power Supply Question - CNCzone.com-The Largest Machinist Community on the net!

mcentric · #1 05-11-2009, 06:10 AM

Am I right in assuming that a 36V DC 9.7A power supply would be suitable for the 3 axis 305oz/in HCNCPRO kit? Any feedback appreciated

miko

rrschmid · #2 05-19-2009, 12:32 AM

Yes, that power supply should work just fine. A regulated power supply would be best. You do not want to go over 40 volts or it can blow the driver chips. HTH
Cheers,
Rich Schmidt

jimglass · #3 09-09-2009, 09:31 PM

Originally Posted by rrschmid

A regulated power supply would be best. Cheers,
Rich Schmidt

Not really. I never use a regulated power supply for my CNC projects. I heard an unregulated power supply is actually better.

Jim

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Power supply question	scrambled	General Electronics Discussion	0	05-20-2008 11:42 PM
Power Supply Question	quamit	General Electronics Discussion	3	09-12-2007 03:53 PM
Yet another Power Supply Question!	chas	General Electronics Discussion	2	03-26-2005 10:48 PM
FNG Power Supply Question	SteinAir	DIY-CNC Router Table Machines	0	12-31-2004 09:31 PM
Power Supply question	Alan T.	Xylotex	5	05-04-2004 08:59 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)