motor com and case ground pro board - CNCzone.com-The Largest Machinist Community on the net!

03-26-2009, 10:21 PM

Ed Williams Ed Williams is offline

Join Date: Feb 2006

Location: US

Posts: 167

motor com and case ground pro board

permalink

I have some connectors I wanted to use. They are 4 pin so I was wondering if I could use the com from motor to case ground and then to com on controller.
Thanks Ed

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Frame ground vs. Electrical ground.	polaraligned	Granite Devices	2	11-24-2008 04:21 PM
grounding question, PC case ground	Fiero Addiction	CNC Plasma and Waterjet Machines	2	08-16-2008 07:40 AM
Need Help!- To Ground or not to Ground That is the question!	Mr.Chips	DIY-CNC Router Table Machines	1	03-16-2008 03:10 PM
Motor Driver where to put ground?	Trapper14	General Electronics Discussion	10	08-08-2006 02:20 AM
Motor supply ground vs Logic ground?	Gashmore	General Electronics Discussion	11	06-07-2005 05:21 PM

All times are GMT -5. The time now is 08:49 PM.