| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Hobbycnc (Products) Discuss Hobbycnc controller boards here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
12-24-2008, 11:58 AM
| |||
| |||
Hi... I run a K2CNC machine driven by the HobbyCNC controller and steppers. All is well... I would like to add a Relay to the Port Cable Spindle so I can automatically turn it on and off with jobs... and I'm looking for suggestions on "how". 1. Which Relay would guys recommend. 2. How is the Relay wired to the router in laymans terms? 3. How is the Relay wired to the HobbyCNC in laymans terms? One crazy question I have is... does the power for the Router come through the Relay now? Or does the Router still plug into the "wall outlet" and the relay is wired into the Router somehow... sorry for the stupid question. I'm confident I can figure out the settings through Mach... but the electrical side I'm always a little miffed by. Rich.  |
|
#2
12-24-2008, 12:50 PM
| ||||
| ||||
| There is quite a few previous posts on similar need. http://www.cnczone.com/forums/showth...ghlight=2n7000 Al.
__________________ CNC, Mechatronics Integration and Machine Design. “Logic will get you from A to B. Imagination will take you everywhere.” Albert E. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Help!- Hobbycnc pro + relay for router start??? | planekrazie | Hobbycnc (Products) | 1 | 06-29-2008 08:13 AM |
| Correct Relay board for Mach and router | WilliamD | Mach Software (ArtSoft software) | 3 | 04-16-2008 06:54 PM |
| CNC4pc Solid State Relay Board. | Smackre | General Electronics Discussion | 20 | 05-21-2006 03:19 PM |
| cnc4pc relay board question | Stuff-Builder | General Electronics Discussion | 14 | 03-17-2006 09:17 AM |
| Mach2 & Rutex relay board. | ynneb | Mach Software (ArtSoft software) | 1 | 08-22-2004 01:50 PM |
| | |
Linear Mode
