Need Help! 4 aupc rev 1 setup - CNCzone.com-The Largest Machinist Community on the net!

heilcnc · #1 08-01-2008, 02:57 PM

i got a 4 aupc rev 1 board years ago from hobbycnc and need info like setting it up tried the yahoo group but this board is 4 years old so the manual is gone from there file section i need the micro step settings and amps settings a copy of the complete manual would be nice thanks

mcyr · #2 08-02-2008, 08:51 AM

Have you tried going to the HobbyCNC website and trying to contact Dave R. directly? I'm sure he'll have the information you need or at least steer you to a site with the information.

Good luck,
Mike

heilcnc · #3 08-02-2008, 09:13 AM

yes i did but he only gave me wiring for board sent him another email for more help no repli thanks

heilcnc · #4 08-03-2008, 10:35 AM

sorry to dave at hobbycnc he sent me the right info i needed the first time i asked i just did not read through it all sorry again to dave at hobbycnc he was right on it thanks

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
CNC setup	mwood3	Benchtop Machines	33	06-19-2008 07:22 AM
Problem- TM3 Setup	Feckless	Torchmate	6	03-24-2008 01:34 PM
What's your setup like...	Scratch	CNC Plasma and Waterjet Machines	1	01-12-2007 01:31 PM
What is your setup?	dolanosa	CNC Wire Foam Cutter Machines	5	10-09-2005 02:00 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)