| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Hobbycnc (Products) Discuss Hobbycnc controller boards here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-11-2008, 10:45 AM
| |||
| |||
i have been running my Taig mill form a few months off of the older board design. I'm only running at 12 volts using 1/4 stepping and notice very little torque. If I was to raise my voltage to 24v what do I need to be cautious about?  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Help..Stuck at relay ext dc voltage missing but dc voltage OK ? | Dirky | Bridgeport and Hardinge Mills | 24 | 11-27-2007 07:33 AM |
| Techno-isel Z axis keeps raising at end of program | irishii75 | Commercial CNC Wood Routers | 8 | 08-24-2007 08:51 PM |
| DC Bus voltage on VF0?? | DomB | Haas Mills | 3 | 03-11-2007 02:14 PM |
| Keeping your zero when raising the head | wcarrothers1 | Benchtop Machines | 11 | 02-10-2007 12:37 AM |
| Max voltage | tekno | PicStep Controllers | 3 | 04-02-2006 05:49 PM |
| | |
Linear Mode
